Forza detailed drawings & specifications

In order to view or download our technical information you need to register to create a login. If you've already registered and received our authorisation email please login below.

Login

*
*

Terms & Conditions of use

By clicking proceed you agree to our terms and conditions of use

REGISTER HERE to set up your user login
Forgot your password?

Register

*
*
*
*
*
*

* indicates a mandatory field

*

By clicking register you agree to our terms and conditions of use

<< Back to login

Enter your email address below

<< Back to login

Forza - Defining Doors
Veneer Guide

FD30 & FD60 Timber Frame Minimum Dimensions and Specification

 

FD30 Flush Frame Specification

           
Material Minimum Density Minimum Frame Face Width - Single Acting Minimum Frame Face Width - Double Acting Minimum Frame Depth Minimum Stop Width
           
Softwood or Hardwood  450kg/m3 32mm excl. Stop 38mm 70mm 12mm
           
MDF  700kg/m3 45mm excl. Stop Not Permitted 70mm 12mm

 
FD60 Flush Frame Specification

Material Minimum Density Minimum Frame Face Width - Single Acting Minimum Frame Face Width - Double Acting  Minimum Frame Depth  Minimum Stop Width 
           
Hardwood 640kg/m3 32mm excl. Stop 38mm 70mm 12mm
           
MDF 700kg/m3 45mm excl. Stop   Not Permitted 70mm  12mm


FD30 Rebated Frame Specification

Material Minimum Density Minimum Frame Face Width -
Single Acting Only
Minimum Frame Depth
       
Softwood or Hardwood 450kg/m3 32mm for the body of the frame, with the door mounted on a 22-24mm projection, with a 32mm deep + 12x12mm rebate to act as a stop 70mm

 
FD60 Rebated Frame Specification

Material Minimum Density Minimum Frame Face Width -
Single Acting Only
 
Minimum Frame Depth 
       
Hardwood 640kg/m3 32mm for the body of the frame, with the door mounted on a 22-24mm projection, with a 42mm deep + 12x12mm rebate to act as a stop  70mm


Note:

1. Timber and MDF frames to have a minimum measured density at 12% moisture content.

2. The complete Forza Doors range of approved sizes and configurations utilising the Forza intumescent seal specification are suitable for use within the above detailed frames.

3. Head/jamb joint: Mortice & tenon or half-lapped (head twice screwed to each jamb) or mitred or butt joint (glued non thermally softening adhesive and head twice screwed to each jamb).

4. Architraves are optional and have no fire performance requirements.

 

 


fis1.jpg GAI_thumb-56px.jpgACS Logos1.jpgribalogo_thumb_56px.jpgForza Doors specification summaries are available through the RIBA Product Selector and NBs Plus